Netfloor STACO Static Control Flooring Systems on-line Brochure

[ Prev ] Page: 1 2 3 4 5 6 7 8 [ Next ]

STACO CO series

Conductive Resilient Access Floor

STACO CO series is an improvement to concurrent conductive access floor systems.
The conductive panel surfaced with conductive vinyl tile without trims at boarders. Two copper strips are bonded at two side of the panel prior to bonding conductive tile. Conductive continuity is contributed by the copper strips, which act as a connecting pathway. Static flows through the conductive tile, copper strip, grid system, and dissipating through the earthing ground point.

Applications
The system is using at hi-tech factory, pharmaceutical, food procession, operation room, hospital ward, computer and control center, arsenal warehouse, and areas where static dissipation through flooring are necessary.

Features:

Conductive property: Surface vinyl static resistance at 10⁴ ~ 10⁶ ohm.
Resilient: Access panel surfaced with homogeneous vinyl tile of 2.0 mm and 3.0 mm thickness. Quiet and comfortable.
Hard-wearing: Pure vinyl 2.0 and 3.0 mm thick, much higher durability than HPL.
Easy maintenance: Gloss surface. Easy clean.
Low maintenance cost than HPL and carpet tile.
Uniform finish: Full piece conductive tile bonded one-to-one alignment on access panel, no trim. Standard panel size is 600 mm x 600 mm and inter-changeable. Provide uniform finish and un-restricted color coordination
Non-combustible and interchangeable access panel.

Conductive Panel: copper strip at center of two side of the panel

Conductive Stringer: Copper strip taped at Center, connect conductive tile and grid system


	STACO CO system patented static conductive stringer and panel system		When conductive panel installed on stringer system, copper strips at center of the panel border contact the copper strips at two side of the stringer. One earthing point made within every 7 pedestals.

[ Prev ] Page: 1 2 3 4 5 6 7 8 [ Next ]