[ Prev ]   Page: 1  2  3  4  5  6  7  8  9  10  11  12  [ Next ]

PDF version for print

Set-Screw Locking System --- innovation for Super Low-Profile installation

 

The Set-Screw Locking System is an unique innovation by Netfloor, specially designed for 40 mm ~ 50 mm super low-profile installation.
 

Set-Screw Locking System - factory assembled UniPanel

  


Super Low-Profle UniPanel, Socket Set-Screw fixed at top
  • Pedestal sets fixed at four corners of panel body.
  • Socket Set- Screws & fastened on top of the pedestals.
  • For height adjustment: 5 mm hex key wrench to loose and fasten the Socket Set-Screw. 4 mm hex key wrench to adjust the pedestal.
 

Height adjustment - After finishing installation, floor deviation in certain areas may cause impact noise by the pedestals. Check by foot-step. Minor adjustment of the pedestals shall be made to descend the pedestals at high point, or to ascend the pedestal to ground at the floor at lower point.
 

Step 1:1

Use 5 mm hex-key wrench to Loose Socket Set-Screw from top.
 

 

Step 2:1

Use 4 mm hex-key wrench to adjust height by stretch through hollow hole of Socket Set-Screw, insert at top of pedestal to adjust upward maximum 55 mm high.
 

 

Step 3:1

Use 5 mm hex-key wrench to fasten Socket Set-Screw from top after adjustment.


4 mm
hex-key wrench
to adjust height


5 mm
hex-key wrench

     

Supper cable highway at super low-profile:under Cable Trench
Capacity: 110 mm width, 35 ~ 45 mm high

 

 

[ Prev ]   Page: 1  2  3  4  5  6  7  8  9  10  11  12  [ Next ]

PDF version for print

Netfloor, Inc. All Rights Reserved.